If your toilet has developed cracks or leaks, uses too much water per flush, or has irregular coloring, it may be time to replace it. A new toilet installation in Savage, MN, is not as difficult as you might think. You will need a few hours, an assistant or a plumber, and the right tools and toilet parts for the job.
Things Required For Toilet Installation
Choose your new toilet before you begin learning how to install a toilet, and make sure you have plumbing ready for the new installation if you are not replacing an existing toilet. The following items will be needed for toilet installation in Savage, MN
- Toilet
- Screwdrivers
- Putty knife
- Water supply line
- Adjustable wrench
- Socket set
- Tape measure
- Toilet seal or a wax ring
Steps To Install A Toilet
Here are some steps for a DIY toilet installation:
- Step 1 – Preparation:
During toilet installation in Savage, MN, you should drain the water by closing the water supply valve and flushing your toilet. The tank lid must be removed, the refill tube must be removed from the overflow pipe, and the water must be drained. Remove the remaining water from the bowl with a sponge and bucket while wearing rubber gloves.
Unscrew the bolts attached to the tank of your toilet, then remove the tank and place it on a towel. Remove the caps and nuts from the bolts on the base of your toilet by using an adjustable wrench. It may be difficult to loosen them, so you may need to cut them with a hacksaw blade if necessary. The caulk seal around your bowl’s base should be cut; the bowl should be removed and set on a towel.
Prevent gas from escaping into the house by covering the drain hole with a rag. The wax seal can be removed from the floor using a knife. Ensure that the drain hole is clean and any rusted bolts are replaced.
- Step 2 – Replacement:
Your new bowl should be caulked around the base, and a wax ring should be placed carefully between the bolts. With the help of a helping hand, carefully place the new bowl over the drain hole.
If your toilet rocks and is uneven, this will eventually result in the wax ring seal breaking and the toilet leaking. Slip stainless steel washers into any gaps to fill in any unevenness. During toilet installation, you should not overtighten this step, or your tank could crack.
Consider brass nuts and bolts when choosing them. You can easily remove them when the time comes since they won’t rust.
- Step 3 – Reassembly:
Reassemble everything you disassembled in reverse order. Consider buying a flexible water supply line when you reattach your water supply line. Compared to plastic or metal versions, they are easier to install. Ensure you hold the hose so it points into the fill valve while you screw on the connectors. Once your toilet is level, check for leaks and turn on your water supply again.
If you’d rather have a professional install your toilet or you need toilet repair services in Savage, MN, look no further than True Plumbing Solutions. Our certified and skilled team is always ready to help you. Contact us today!